Clutch (Sac Pressure Plate) With 6CYLINDER 2.7 Liter Bi turbo

Clutch (SAC pressure plate) for vehicles with 6cylinder 2.7 liter bi turbo engine
Before working on the clutch, the transmission must be removed, Refer to Manual Transaxle, Service and Repair.

1. Dual mass flywheel
^ Ensure centering pins are tightly seated
^ Contact surface for clutch lining must be free of grooves, oil and grease
^ Removing and installing, Refer to Transmission and Drivetrain
2. Bolt
^ Vehicles with dual mass flywheel: tighten bolt to 60 Nm, then turn a further 180°
^ Always replace
3. Clutch plate
^ Install with spring pack (coil springs) or the word "Getriebeseite" towards pressure plate and transmission
^ Centering, Refer to Adjuster Ring In Sac Clutch Pressure Plate, Resetting
^ Do not grease
^ Clutch plate diameter, Refer to Manual Transaxle, Application and ID.
4. SAC pressure plate
^ Removing and installing, Refer to Adjuster Ring In Sac Clutch Pressure Plate, Resetting
^ Resetting adjuster ring, Refer to Adjuster Ring In Sac Clutch Pressure Plate, Resetting
^ Checking ends of diaphragm spring, Refer to Fig. 1
^ Checking spring connection and riveted fastenings
5. Bolt, 22 Nm
^ Tighten gradually in diagonal sequence and in several stages
6. Needle roller bearing





Fig. 1 Checking ends of diaphragm springs
Wear up to half of the diaphragm spring thickness is permissible
- Check diaphragm springs and spring connection between pressure plate and cover for cracks, rivet connections and for secure fit.
- Replace clutches with damaged springs or with loose rivet connections (arrows).

Note: In case of repair, always allocate clutch pressure plate and clutch disc to engine code according to parts Supplier.