Brake Calipers, Servicing

Brake Calipers FN3
Brake calipers, servicing

Notes:
^ Install complete repair set when servicing.
^ New brake calipers are filled with brake fluid and are pre-bled.
^ Apply thin coat of paste G 052 150 A2 to brake cylinders, pistons and seals.

1. Caps
^ Insert into bearing bushing
2. Guide pin, 25 Nm
3. Vent valve
^ Apply thin coat of assembly paste G 052 150 A2 to thread before screwing in
4. Protective cap
^ Attach to bleed valve
5. Brake caliper housing
6. Retention spring
^ Insert both ends into the holes in the brake caliper housing

Notes: After inserting the retaining spring into the two holes, press it under the brake carrier. If incorrectly installed, it is not possible to adjust the wear of the outer pad, and the pedal travel will be increased as a result.

7. Bushing
^ Insert into brake caliper housing
8. Brake carrier
^ Bolt to brake caliper housing
9. Sealing ring
10. Piston
^ Apply thin coat of assembly paste G 052 150 A2 to piston before inserting
11. Protective cap
^ Do not damage when inserting piston