Transmission Input Speed Sensor-G182-

5 Speed Automatic 01V

Transmission input speed sensor-G182-, replacing

Note: A distinction is made between two types of transmissions.

- Transmission with hydraulic control E17, on which the sensor for transmission RPM (inductive sensor) is secured to the underside of the valve body.
- Transmission with hydraulic control E1812, on which the sensor for transmission RPM (hall sensor is secured behind the valve body on transmission housing.

For transmissions with hydraulic control E17
Removing
- Remove valve body.





- Turn valve body on its back and disconnect connector at Transmission Input Speed Sensor-1-.





- Unbolt Transmission Input Speed Sensor-1- at valve body.

Installing
- Use two spacer sleeves -2- (height: 20 mm) to install Transmission Input Speed Sensor -1- and tighten to 7 Nm.
- Installation position: Sensor side with connector pins faces valve body center.





- Connect connector for Transmission Input Speed Sensor-1
- Install valve body.
- Top up ATF.

For transmissions with hydraulic control E18/2
Removing
- Remove valve body.





- Unscrew Transmission Input Speed Sensor -A- from transmission.

Installing
- Bolt Transmission Input Speed Sensor -A onto transmission with bolt -B-. The tightening torque is 9 Nm.





- Route wire with connector-C according to illustration so that the wiring is not pinched during installation of the valve body.
- Install valve body.
- Fill up ATF.