With Manufacturers Scan Tool

Erase DTC Memory (Function 05)

Requirements:
- DTC memory checked.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Enter "05" for "Erase DTC Memory" function and confirm entry with Q key.

Indicated on display:


Rapid data transfer ->
DTC memory is erased!


- Press -> key.

Indicated on display (function selection):


Rapid data transfer HELP
Select function XX


NOTE:
Indicated on display:

Attention!
DTC memory was not interrogated

or

Rapid data transfer ->
DTC memory was not interrogated


Sequence of operations was not carried out properly.
- Check DTC Memory:
- Repair malfunction, if necessary, then Check DTC Memory.

Follow test sequence exactly; First check DTC memory and if necessary, repair malfunction and then erase.

Perform End Output (function 06) after erasing DTC memory; switch ignition off and on again; check DTC memory again.

End Output (Function 06)

Indicated on display:


Rapid data transfer HELP
Select function XX


- Enter "06" for "End of output" function and confirm entry with Q key.

Indicated on display:


Rapid data transfer HELP
Enter address word XX


- Detach diagnostic connectors.