Front Bumper (Audi RS6)

Bumper, Fastening To Impact Absorber (RS6 Only)







NOTE:
- The bushings in the impact absorber compensate for tolerances in the height between the bumper and the impact absorber when the socket-head bolts are installed.
- The front bumper is held to the previously set position when socket-head bolts -1- are installed.

1 - Socket-head bolt
- 23 Nm (16 ft.lb)
- M8 x 132
2 - Carrier bushing, lower
- Plastic part, pressed into adjusting screw
- No replacement







3 - Adjusting screw, lower
- Screw fully in before installing bumper
- Left-hand thread
- No replacement
4 - Threaded bushing, lower
- Secure with locking pin
- No replacement
5 - Locking pin
- No replacement
6 - Impact absorber
7 - Threaded bushing upper
- Secure with locking pin
- No replacement







8 - Adjusting screw - upper
- Screw fully in before installing bumper
- Right-hand thread
- No replacement
9 - Bumper cover
10 - Nut
- Supplied with replacement cross member
11 - Carrier bushing - upper
- Plastic part, pressed into adjusting screw
- No replacement
12 - Cross member