"Zero" Position of Guide Plate, Checking and Adjusting

"Zero" Position Of Guide Plate, Checking And Adjusting

Checking
The "zero" position can be checked using a pocket mirror and a flashlight, with the sunroof panel installed.
- Trims removed
- Run sunroof panel back and then into closed position.
- Push sliding headliner fully back.
- Place flashlight onto sunroof panel and visually check "zero" position from side.







The "zero" position of the guide plate is correctly set if the square hole in the tilt mechanism of the guide plate - 1 - is aligned with the recess (arrow) in the guide rail - 2 -.

Adjusting
- Sunroof panel removed
- Sunroof motor removed
- Trims removed
- Slide guide plates - 1 - on both sides from rear to front.







- Align square hole in tilt mechanism of guide plate - 1 - with recess (arrow) in guide rail - 2 - for sliding headliner.
This is the "zero" position.
- Install sunroof motor in "zero" position.