Cruise Control System, Activating/Deactivating

Cruise Control System, Activating/deactivating

NOTE:
- On vehicles equipped with CCS, the CCS function has to be activated following replacement of the engine control module.
- An entry is made in the fault memory if the CCS function is activated in the engine control module of a vehicle not equipped with CCS. In such cases the CCS function has to be deactivated.

Work sequence
- Connect vehicle diagnostic, testing and information system VAS 5051 and select vehicle system "01 - Engine electronics" from list. Ignition must be on. Connecting VAS 5051 Scan Tool

Indicated on VAS 5051:







- From list -1- select diagnostic function "11 - Encoding II".

Indicated on VAS 5051:







1 Enter code word

Activating CCS
- Use keypad -2- to enter "11463" and confirm entry by touching Q key.

Deactivating CCS
- Use keypad -2- to enter "16167" and confirm entry by touching Q key.
- End function "11 - Encoding II" by touching <- key.

Indicated on VAS 5051:







- From list -1- select diagnostic function "08 - Reading measured value block".

Indicated on VAS 5051:







1 Enter display group
- Use keypad -2- to enter "066" for "Display group number 066" and confirm by touching Q key.

Indicated on VAS 5051:







- Check display in zone -2-.

Display Group 066:

- End function "08 - Reading measured value block" by touching <- key.
- Touch "06 - End of output".
- Switch off ignition.