Timing Component Alignment Marks: Locations

WARNING: Engine must only be turned over at crankshaft in direction of engine rotation (clockwise).

- Set crankshaft to markings for TDC of No. 5 cylinder by turning central bolt on crankshaft sprocket in direction of rotation.





^ Notch -B- aligned with marking -A-.

Note: Turn over engine at center bolt on crankshaft.

- Check position of camshafts-.





^ Larger holes (arrows) in securing plates on camshaft sprockets should point inward.

- If this is not the case, turn crankshaft one complete revolution.

Note: There is a TDC hole in crankshaft directly behind plug (it is possible to feel the hole).

WARNING:
^ Risk of injury - do not turn crankshaft while feeling for TDC hole with a finger.