Sealing Flanges and Drive Plate, Removing and Installing

Sealing flanges and drive plate, removing and installing

1 - 10 Nm
2 - Baffle plate
3 - 14 Nm
4 -14 Nm
^ Bolt with strength rating 10.9
5 - Oil seal
6 - Oil spray jet valve - 35 Nm
7 - O-ring
^ Always replace
8 - Front sealing flange
9 - Gasket
^ Always replace
10 - Thrust ring
11 -Gasket
^ Always replace
12 - Rear sealing flange with oil seal
13 - Shim
^ 3.4 mm thick
14 - Drive plate
15 - Washer
^ 1.5 mm thick
16 - 30 Nm plus an additional 90° (1/4 turn)
17 - 10 Nm
18 - 14 Nm
19 - 10 N m
^ Tighten in stages and in diagonal sequence
20 - Sump (lower section)