Sensor For Transmission RPM - G182, Removing and Installing

Sensor for transmission RPM - G182, removing and installing

Note: Do not re-use a sensor that was dropped (the permanent magnet breaks).

Removing
- Remove valve body.





- Disconnect connector -A- on backside of valve body.
- Remove sensor for transmission RPM - G182 -B- at valve body.

Installing





- Install sensor for transmission RPM -1- using spacers -2- (length 8.7 mm).
- Install connector on sensor.
- Install valve body.

Note: The sensor side with the connector terminals points toward the valve body.

- Replace ATF or refill after repair.





Tightening Torque