Headlight Range Control Module -J431-, Removing and Installing - Roadster

Headlight Range Control Module -J431- Roadster, Removing and Installing - Roadster

Removing


CAUTION!
Before Beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

1. Remove rear side panel trim, please refer to Body and Frame/ Interior Moulding/Trim/ Trim Panel/ Service and Repair/ Service and Repair






2. Release nuts - arrows -.

3. Remove module -1-.

4. Disconnect electrical connection -1-.

Installing

1. Install in reverse of removal, noting the following:
- OBD function - "Basic setting" must be performed on -J431- when replacing - VAS 5051/5052 in operating mode "Guided Fault Finding".

Tightening Torques
Component Nm
Control Module to Body 2.5