Ribbed Belt For Generator, Vane Pump and A/C Compressor

Ribbed belt for generator, vane pump and air conditioner compressor

Note: Mark direction of ribbed belt with chalk or felt-tip pen prior to removal. Running a used belt in the opposite direction could destroy it. When installing belt, make sure it is properly seated on pulleys.

1. 25 Nm
2. Tensioning roller
3. Ribbed belt
^ Mark direction of rotation before removing
4. 25 Nm
5. Bracket
^ For generator, vane pump and air conditioner compressor
6. 40 Nm
7. Generator
^ Removing:
See Caution before beginning repairs on electrical system, Refer to Engine, Service Precautions
- Disconnect battery Ground strap
- Slackening ribbed belt and removing from generator, Refer to Drive Belt, Service and Repair
- Loosen bolted connection at top and bottom.
- Swivel generator to side slightly and disconnect electrical connections from generator.
- Remove generator.
8. 20 Nm
9. 40 Nm
10. 20 Nm
11. Vane pump
12. 40 Nm
13. Air conditioner compressor
^ When installing, pay attention to dowel sleeves in screw-on holes
14. 20 Nm
15. Vibration damper/pulley
^ Can only be installed in one position, Refer to Fig 1
16. Collared bolt
^ Installation instructions, Refer to Fig 1
17. Idler wheel
^ Secured to bracket for generator, vane pump and air conditioner compressor
18. Special bolt 25 Nm
^ For idler wheel





Fig. 1 Installing vibration damper / pulley
^ Lock carrier in service position, Refer to Body and Frame, Radiator Support, Service and Repair
^ Remove ribbed belt.
^ When installing vibration damper, only use genuine bolts:
Refer to Parts Supplier
^ Vibration damper can only be installed in one position: Hole -arrow in vibration damper must fit over projection on toothed belt sprocket.