Hose Plan, EVAP Canister System / Leak Detection System

Hose Plan, EVAP Canister System / Leak Detection System







1 - Check-valve
- Installation position (light/dark side): Arrow on valve points in direction of flow, as shown in illustration.
2 - Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- Component location: Front right in engine compartment
3 - Vent line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- Installation position: Right side, beneath vehicle floor
- secured to fuel tank in fuel tank area
4 - Vent line
- to gravity valve on fuel tank
5 - EVAP canister
- Component location: Bottom of spare wheel well
6 - Connection hose
- Leak Detection Pump (LDP)/EVAP canister
- Pressure side
7 - Air filter housing
- for Leak Detection Pump (LDP) -V144-
8 - Leak Detection Pump (LDP) -V144-
- Component location: Under wheel housing liner in rear left wheelhouse
9 - Vacuum line
- Leak Detection Pump (LDP)/throttle valve control module
10 - Check-valves
- Installation position (light/dark side): Arrow on valve points in direction of flow, as shown in illustration.
11 - T-piece
- Component location, see Fig. 1
12 - Throttle valve control module -J338-

Fig. 1 Component location of T-piece







T-piece (arrow) is located on the left in engine compartment.