Control Module, Fresh Air Blower -J126- & -V2- Remove & Install

Control Module For Fresh Air Blower -J126- And Fresh Air Blower -V2-, Removing And Installing

Removing
- Remove glove compartment:







- Disconnect connector -A-.
- Remove lower A-pillar trim.
- Loosen cable tie -B-.
- Tilt carpet carefully toward back.







- Press sound insulation mat aside, until rear screw -C- is reachable.
- Unscrew bolts -C-.
- Press sound insulation mat aside and pull fresh air blower -D- out of air conditioner.

NOTE:
- The Control module for fresh air blower -J126- is integrated in the Fresh Air Blower -V2-, and cannot be replaced separately.
- Observe correct seating position when installing the fresh air blower into the air conditioner.

Installing
Installation is the reverse of removal.