Throttle Position Sensor: Service and Repair

Accelerator Pedal Module With Throttle Position (TP) Sensors, Removing And Installing

- Remove driver-side storage compartment.







- Disconnect 6-pin harness connector -2-.
- Remove bolts -1- and -3-.
- Remove accelerator pedal module.

Installing
Installation is the reverse of removal, noting the following:
- In a vehicle with automatic transmission, the kickdown function must be adapted when accelerator pedal module is replaced: To do so, switch on ignition and press accelerator pedal all the way down past the kickdown point and hold in position for at least 20 seconds.
- Switch ignition off.
- Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on again

Tightening torque

Component Nm
Accelerator pedal module to pedal mount 10