Front Side Airbag Crash Sensor, Removing and Installing

Front Side Airbag Crash Sensor, Removing And Installing

CAUTION: Observe safety precautions for working on airbag on airbag.







- Removing
- Disconnect battery Ground (GND) strap.
- Remove side trim.
- Remove belt reel of front seat belt.
- Remove belt reel insulation.
- Remove bolts - 2 - (2x).
- Tightening torque 9 Nm
- Disconnect connector on crash sensor - 1 - and remove crash sensor - 1 -.







- Installing
- Install crash sensor - 1 - in reverse order of removal.
- Switch ignition on.

CAUTION: There must be no one in the vehicle when the battery is being connected.

- Connect battery Ground (GND) strap.

NOTE:
- After connecting the battery observe the necessary measures.
- If Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after assembly, use vehicle diagnostic, testing and information system VAS 5051 A to interrogate, erase and then again interrogate DTC memory.