4-Way Relay Carrier In E-Box In Plenum, Removing and Installing

4-way Relay Carrier In E-box In Plenum Chamber, Removing And Installing

Removing


NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.


- Remove rubber seal for plenum chamber cover.







- Remove plenum chamber cover -1- toward front -arrows-.







- Use a screwdriver to pry off the two caps -3- .
- Loosen hex nuts -4- by several turns.
- Loosen wiper arm -2- from wiper shaft by lightly tilting.
- Remove hex nuts completely and remove wiper arms.
- Disconnect securing clips -1- and remove cowl panel grill -5-.







- Remove cover for E-box, plenum chamber -arrows-.







- Using a screwdriver, pry off retaining bracket -arrow-.
- Set aside Engine Control Module (ECM) with cables connected.
- Unclip Transmission Control Module (TCM) retaining bar.
- Set aside Transmission Control Module (TCM) with cables connected.







- Disengage catches -arrows- and remove auxiliary relay carrier in E-Box toward top.
- Unclip fuse carrier at 4-way relay carrier.
- Remove relays, control modules, and then unclip appropriate relay carrier.


NOTE:







Check the exact assignment of 4-way relay carrier, E-Box plenum chamber in the current wiring diagram.

Installing
Installation is reverse of removal, paying attention to the following:


NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.