4-Way Relay Carrier, Removing and Installing

4-way Relay Carrier, Removing And Installing

Removing
- Remove driver's storage compartment







- Remove bolts -1- for fuse box -2-.
- Remove fuse box from center tube for instrument panel.
- Detach wiring harness on center tube for instrument panel and set aside.
- Remove relay or control modules from 4-way relay carrier.







- Mark cables at screw connections -2-, -3- and -5-.
- Remove cables from screw connections.
- Remove bolt -1- and nut -4-.
- Unclip fuse carrier at 4-way relay carrier.
- Remove relays, control modules, and then unclip respective relay carrier.


NOTE:







Check the exact assignment of 4-way relay carrier in the current wiring diagram.

Installing
Installation is reverse of removal, paying attention to the following:







- Attach cables to screw connections -2-, -3- and -5- according to markings.

Tightening torques
4-way relay carrier to body: 2.4 Nm
Screw connections for electrical cables: 9 Nm


Connection point, left







Location: The left connection point -arrow- is located in the left footwell
below A-pillar trim.
- Remove A-pillar trim.


NOTE:







Check the exact assignment for connection point in the current wiring
diagram.

Connection point, right







Location: The right connection point -arrow- is located in the right footwell
below A-pillar trim.
- Remove A-pillar trim.


NOTE:







Check the exact assignment for connection point in the current wiring
diagram.