Lock Carrier, Service Position

Lock carrier service position

Note: Do not remove noise insulation, only loosen front quick-release bolts.

Bumper removed.






1. Lock carrier

For service position
- Detach engine cover -2- and -3-.
- Unbolt and take out air duct between lock carrier and air cleaner (air duct is bolted to lock carrier).
- On the left-hand side, screw special tool 3369 into thread. See Fig. 6
- Screw in special tool 3369 on right side.
- Securing bolts -5- unscrew left and right.
- Remove securing bolts -4- and pull lock carrier -1- forward.
- Fasten lock carrier. See Fig. 7.

2. Left engine cover
3. Right engine cover
4. Combi-bolt 10 Nm
5. Combi-bolt 50 Nm
For service position screw in special tool 3369.

Note: After installing lock carrier, check headlight settings and adjust, if necessary.

Fig. 6 inserting special tool 3369






- Screw in special tool 3369 on left and right as shown.
- Pull lock carrier forward until rear hole in lock carrier aligns with front threaded hole in fender flange.

Fig. 7 Securing lock carrier






- Secure lock carrier in position on left and right using bolts as shown.