Oxygen Sensor Before Catalytic Converter
Oxygen Sensor Before Catalytic ConveterSpecial Tools and Workshop Equipment
- Box Wrench Set -3337-
- High-Temperature Paste -G 052 112 A3-
Removing
- Disconnect connector of relevant oxygen sensor
- Undo cable ties.
- Remove Oxygen sensor using special tool -3337-.
Installing
NOTE:
- The screw thread on the oxygen sensor is coated with assembly past. This past must not be allowed to penetrate the openings on the sensor.
- When installing, the cable ties must be re-installed at exactly the same points in order to prevent contact between the oxygen sensor wire and the exhaust pipe.
Tightening Torque: 55 Nm