Evaporative Emissions System: Locations

EVAP Canister/Leak Detection System (Front And All Wheel Drives)

EVAP canister/leak detection system - component overview

Component Locations, Overview:

1 Cap nut - 10 Nm
2 Cover
- For EVAP canister
3 Stud bolt - 15 Nm
4 Sealing piece
5 Vent line
- From gravity valve at fuel tank
- To remove, press release ring on EVAP canister
6 Vent line
- to Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- To remove, press release ring on EVAP canister
7 Air filter housing
- for Leak Detection Pump (LDP) -V144-
- no maintenance procedure
8 7.5 Nm
9 Vacuum line
- to Leak Detection Pump (LDP) -V144-
10 Cable ties
- for securing vacuum line to Leak Detection Pump (LDP) bracket
11 Leak Detection Pump (LDP) -V144-
- Component location: Under wheel housing liner in rear left wheelhousing
12 Electrical 3-pin harness connector
- Black
13 Connection hose
- Leak Detection Pump (LDP)/EVAP canister
- Pressure side
- to remove, press release button at connection on Leak Detection Pump (LDP)
14 Connection hose
- Leak Detection Pump (LDP)/air filter
15 Cable ties
- for securing hose to Leak Detection Pump (LDP) bracket
16 Sealing piece
17 Cable ties
- for securing connection hose to wheel housing
18 EVAP canister
- Component location: Bottom of spare tire well