FWD

Fuel Pump (FP) And Sender For Fuel Gauge - Component Overview

Component Locations, Overview:

1 Sender for fuel gauge -G-
2 Fuel pump
- Check Fuel Pump (FP) electrically
- Checking fuel delivery
- Checking residual pressure
3 Seal
- Always replace
- to install, place into opening of fuel tank when dry
4 Fuel return line
- Mark before removing
- To disconnect, press release button on connection piece
- Do not bend
- Note direction of arrow (fuel supply or return) on connector flange when installing
- Clipped in on fuel tank
5 Fuel supply line
- Mark before removing
- To disconnect, press release button on connection piece
- Do not bend
- Note direction of arrow (fuel supply or return) on connector flange when installing
- Clipped in on fuel tank
6 Electrical harness connector
- for Fuel Pump (FP) and sender for fuel gauge -G-
- Releasing Fig. 1
7 Union nut - 80 Nm
- Use ring nut spanner 3217 to remove and install
8 Suction jet pipe
- To disconnect, press release button on connection piece
9 Suction jet pump

Fig. 1 Releasing harness connector







- To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a small screwdriver -arrow-.