Central Locking System Component Overview (Sedan)

Component Overview (Sedan)







1 - Front Passengers Door Control Module J387
- Integrated in window regulator.
2 - Right Rear Door Control Module J389
- Integrated in window regulator.
3 - Fuel Tank Lid Unlock Motor V155
- Removal
4 - Rear Lid Unlock Motor V139
5 - Left Rear Door Control Module J388
- Integrated in window regulator.
6 - Drivers Door Control Module J386
- Integrated in window regulator.
7 - Comfort System Central Control Module J393
- Before removing, disassemble left front seat
- Remove lower A-pillar trim.
- Remove lower A-pillar trim.
- Removal
8 - Front Hood Switch F266
- Component location in lock carrier







Removing Comfort System Central Control Module J393
- Left front seat and lower A-pillar trim removed.
- Ignition switched off.
- Open box - 1 - for control module.
- Disconnect harness connector from control module - 2 - and remove it.







Removing Fuel Tank Lid Unlock Motor V155
- Disconnect electrical connector.
- Loosen bolts - arrows - using special tool T10010, slide actuator - 1 - toward front and remove.
- Before installing actuator, emergency release - 3 - must be slid over the locking pin.
- Locking pin of actuator must move cleanly into closed fuel filler flap - 2 -.