Power Trunk / Liftgate Lock Actuator: Service and Repair

Rear Lid Lock Actuator, Removing And Installing

Removing
- Remove lower rear lid trim.







- Disengage operating rod - 3 - at rear lid lock, for this purpose turn hinge arm - 4 - clockwise and remove operating rod.
- Disengage operating rod at actuator - 1 -, for this purpose slide operating rod to actuator and turn approx. 90 degrees out of mount - arrow -.
- Loosen bolts - 2 - approx. 2 rotations and disengage actuator at rear lid.
- Disconnect electrical harness connector.







- Remove bolts - 3 -.
- Tightening torque 2 Nm
- Remove adapter plate - 2 - from actuator - 1 -.

Installing
Installation is performed in the reverse order of removal.