FWD

Fuel Pump (FP) And Sender For Fuel Gauge - Component Overview







1 - Sender for fuel gauge -G-
2 - Fuel pump
- Check Fuel Pump (FP) electrically
- Checking delivery quantity
- Checking residual pressure
3 - Seal
- to install, place into opening of fuel tank dry
4 - Fuel return line
- from fuel filter
- Mark before removing
- To disconnect, press release button on connection piece
- Do not bend
- Note direction of arrow (fuel supply or return) on connector flange when installing
- Clipped in on fuel tank
5 - Ventilation line
- from fuel pressure regulator in fuel filter
- To disconnect, press release button on connection piece
- Do not bend
- Clipped in on fuel tank
6 - Fuel supply line
- To fuel filter
- Mark before removing
- To disconnect, press release button on connection piece
- Do not bend
- Note direction of arrow (fuel supply or return) on connector flange when installing
- Clipped in on fuel tank
7 - Electrical harness connector
- for Fuel Pump (FP) and sender for fuel gauge -G-
- Disengaging, see Fig. 1
8 - Locking ring
- Use ring nut wrench 3087 to remove and install
- Tighten to 145 Nm
9 - Suction jet pipe
- To disconnect, press release button on connection piece
10 - Suction jet pump

Fig. 1 Releasing harness connector







- To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a small screwdriver -arrow-.