Removal and Replacement

Airbag Control Module - J234 -, Removing And Installing

Special tools, testers and auxiliary items required







- Torque wrench V.A.G 1410







- Vehicle Diagnosis, Testing and Information System VAS 5051 A

CAUTION: Observe safety precautions for work on airbags.







1 - Airbag Control Module
- Removal:
- Disconnect the battery ground (GND) strap.
- Remove center console.
- Position securing clip - 4 - on connector - 3 -.
- Remove connector - 3 - from control module - 1 -.
- Remove bolts - 2 - (Qty. 3).
- Remove control module.
- Installing:
Installation is reverse of removal.

NOTE:
- Follow safety measures after connecting battery.
- If the Airbag Malfunction Indicator Lamp (MIL) K75 shows a malfunction after assembly, DTC memory must be checked with Vehicle Diagnostic, Testing and Information System VAS 5051 A , cleared and then rechecked.
- After replacing control module, it must be coded.

See Guided Fault Finding, Airbag 8.4E, Electrical Components, J234 Airbag Control Module, J234 Airbag Control Module, coding.

2 - Bolts (3x)
- Tightening torque 7 Nm
3 - Connector
4 - Securing bracket