Crash Sensor For Rear Side-Airbag, Assembly Overview

Crash Sensor For Rear Side-airbag (Side Curtain Airbag), Assembly Overview

WARNING: Observe safety precautions for working on airbags.







1 - Crash sensor for side airbag rear, driver's side -G256- and passenger side -G257-
- Removal

NOTE: In the illustration, crash sensor for rear side-airbag is depicted on the passenger side. Removal and installation on the driver side proceeds in the same manner.

See Cautions before beginning repairs on electrical system

- Disconnect battery Ground (GND) strap.
- Remove side panel.
- Disengage tab on yellow connector -3-and disconnect connector.
- Remove two bolts -2- at crash sensor.
- Installing
- Switch ignition on.

WARNING: No person may be inside the vehicle when connecting the battery.

See Cautions for connecting Telematics battery

- Connect battery Ground (GND) strap.
2 - Bolts (2x)
- Tightening torque 9 Nm.
3 - Acceleration sensor connector

NOTE:
- Observe safety precautions after connecting the battery.
- If Airbag Malfunction Indicator Lamp (MIL) -K75- signals a malfunction after installation, DTC memory must be interrogated, erased and once again interrogated using VAS 5051 tester.