Bumper, Fastening to Impact Absorber

Bumper, Fastening To Impact Absorber







NOTE:
- The bushings in the impact absorber compensate for tolerances in the height between the bumper and the impact absorber when the socket-head bolts are installed.
- The front bumper is held to the previously set position when socket-head bolts - 1 - are installed.

1 - Socket-head bolt M8 x 132
- 23 Nm (17ftlb)
2 - Carrier bushing, lower
- Plastic part, pressed into adjusting screw
- No replacement
3 - Adjusting screw, lower
- Screw fully in before installing bumper
- Left-hand thread
- No replacement







4 - Threaded bushing, lower
- Secure with locking pin
- No replacement
5 - Locking pin
- No replacement
6 - Impact absorber
7 - Threaded bushing upper
- Secure with locking pin
- No replacement
8 - Adjusting screw, upper
- Screw fully in before installing bumper
- Right-hand thread
- No replacement







9 - Bumper cover
10 - Nut
- Supplied with replacement cross member
11 - Carrier bushing, upper
- Plastic part, pressed into adjusting screw
- No replacement
12 - Cross member