Rear Suspension (FWD)

Wheel bearing/wheel hub unit, removing and installing
Special tools and equipment





^ 80-200 pry lever for removing outside mirror

Removing
^ Vehicle is standing on its wheels over a car lift
^ Remove hubcap, for light-alloy wheels pull off center cap from disc wheel.
^ Raise vehicle.
^ Remove wheels.





^ Unscrew attachment bolts (arrows) from brake caliper housing.
^ Remove brake pads.
^ Hang brake caliper on body.
^ Remove brake disc.
^ Remove bracket for wheel speed sensor





^ Pull out ABS wheel speed sensor.





^ Unscrew bolts for wheel bearing/wheel hub unit.
^ Remove wheel bearing/wheel hub unit with backing plate for brake disc.

Installing
Installation is the reverse of removal.
^ Contact surface for wheel bearing1wheel hub and threaded holes must be free of paint and dirt
^ Tighten wheel hub unit and backing plate to rear axle to 60 Nm.
^ Install new ABS wheel speed sensor





^ Insert ABS wheel speed sensor -1- until it stops.
^ Locating tab -A- faces toward front on left side of vehicle and rear on right side.
^ Mount bracket for wheel speed sensor.
^ Mount brake disc with pads, and tighten brake caliper to 35 Nm.
^ Wheel bolt tightening torque: 120 Nm