Accelerator Pedal Module W/TP Sensors, Removing and Installing

Accelerator Pedal Module With Throttle Position (TP) Sensors, Removing And Installing

- Remove driver-side storage compartment.
- Disconnect 6-pin harness connector.
- Remove threaded connections (3x).







- Remove accelerator pedal module (arrow).

Installing
Installation is the reverse of removal, noting the following:
- Remove accelerator pedal module (arrow).
- In a vehicle with automatic transmission, the kickdown function must be adapted when accelerator pedal module is replaced: To do so, switch on ignition and press accelerator pedal all the way down past the kickdown point and hold in position for at least 20 seconds.
- Switch ignition off.
- Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on again

Tightening torque

Component Nm
Accelerator pedal module at pedal mount 9