Rear ABS Wheel Speed Sensor, Removing and Installing

ABS wheel speed sensor, removing and installing

Special tools and equipment
- 80-200 pry lever

Removing
- Lift rear seat bench out of locking mechanism.





- Disconnect ABS wheel speed sensor harness connector and push out grommet (arrow).
- Raise vehicle.





- Disconnect ABS wheel speed sensor wiring from retainers (arrows).
- Remove retainer for ABS wheel speed sensor.





- Pry ABS wheel speed sensor from wheel bearing/hub unit using 80200 pry lever.

Installing
- Before inserting ABS wheel speed sensor, lubricate circumference of seal with brake cylinder paste.








- Insert ABS wheel speed sensor -1- until stop.
- Locating tab -A- faces front on left and rear on right.
- Push ABS wheel speed sensor into wheel bearing housing by hand.
- Insert retainer for ABS wheel speed sensor.

Note: When routing the ABS wheel speed sensor wiring note the following:





- Route ABS wheel speed sensor wiring -1- next to brake line -2- on both sides as shown.
- On the left side, maintain a clearance of about 2 cm between the heat shield on the exhaust system and ABS wheel speed sensor wiring.





- On right-hand side, ABS wheel speed sensor wire -1- must be routed between fuel lines -2-.