Operation CHARM: Car repair manuals for everyone.

Round Housing



Brake light switch (round housing), removing and installing

Note: To ensure a secure fit, the switch may only be installed once.

Removing
- Remove driver's storage compartment
- Unplug electrical connector.
- Turn brake light switch 45° counter-clockwise to remove.

Installing
Installation is carried out in the reverse sequence; note the following points:





- Pull out plunger of brake light switch as far as it will go -arrow-.
- Insert switch into its mounting so that retaining tabs -1- and -2- engage in corresponding slots and secure by turning 45°- clockwise.

Note:
^ Do not press brake pedal while installing switch.
^ The plunger in the switch is adjusted automatically when switch is inserted.

- Check function of brake lights with brake pedal pressed and with pedal released.