Engine Specifications

Technical data
Engine number





The engine number (engine code and serial number) is on the machined surface on the cylinder block, at the front of the right cylinder bank.
The engine code is also indicated on the vehicle data sticker.








Engine data
1) Fuel with not less than 95 RON can also be used, but this will cause a loss of power.

Tightening Torques (Part 1 Of 9):

Tightening Torques (Part 2 Of 9):

Tightening Torques (Part 3 Of 9):

Tightening Torques (Part 4 Of 9):

Tightening Torques (Part 5 Of 9):

Tightening Torques (Part 6 Of 9):

Tightening Torques (Part 7 Of 9):

Tightening Torques (Part 8 Of 9):

Tightening Torques (Part 9 Of 9):

"For information regarding" Cylinder Head Tightening Torque and
Sequence, Refer to Cylinder Head, Service and Repair Service and Repair

"For information regarding" Camshaft Bearing Cap Tightening Torque and Sequence, Refer to Camshaft, Service and Repair Service and Repair

Crankshaft bearing caps, installing
- Bearing -1- is at the toothed belt end; bearing -4- is at the flywheel end.





Tightening sequence
- Stage 1- Tighten all bolts in sequence shown (1-16) to 30 Nm.
- Stage 2- Tighten all bolts in sequence shown (1-16) to 60 Nm.
- Stage 3- Using a fixed wrench, turn all in sequence shown (1-16) 90° further.
- Tighten bolts -A- to 25 Nm.

Conrod bearing bolts
^ Always replace
^ Tightening torque: 30 Nm + 90 (1/4 turn)
^ When measuring radial clearance, tighten to 20 Nm but do not turn further.

Camshaft bearing caps and camshaft adjuster 10 Nm
Exhaust manifold to cylinder head 25 Nm
Front exhaust pipe to exhaust manifold 25 Nm
Oxygen sensor 50 Nm
Spark plugs 25 Nm
Toothed belt sprocket to camshaft 55 Nm
Intake manifold to cylinder head 10 Nm
Cylinder head cover 10 Nm
Water pump
Bolts M6 10 Nm
Bolts M8 20 Nm
Oil pump to cylinder block 25 Nm
Oil pump supply pipes to upper section of sump 10 Nm

Tightening torques

Notes:
^ Tightening torques are valid only for nuts and bolts that are lightly greased, oiled, covered with a thin coat of phosphate or blackened.
^ Additional lubricants such as engine or transmission oil may be used as long as they do not contain graphite.
^ Do not use any degreased parts.
^ Permissible deviations for tightening torques => 15%.








Manual Transmission
Transmission to engine (6-cylinder)
-A- Centering sleeves








Automatic Transmission
Engine/gearbox mountings (6-cylinder engine)
-A- Dowel sleeves for centering








Threaded Assemblies