FWD

Fuel Pump (FP) and Sender For Fuel Gauge, Component Overview

Front Wheel Drive (FWD) vehicles







1 Sender for fuel gauge -G-
2 Fuel screen
- Not individually replaceable
- Clean if soiled
3 Fuel pump
- Can be replaced only complete with connector flange
- Fuel Pump, checking (FP)
4 Connector flange
- Not individually replaceable
- Installation position: Note arrow marking
5 Fuel return line
- From engine
- Mark before removing
- Note direction of arrow on connector flange
6 Fuel supply line
- To fuel filter
- Mark before removing
- Note direction of arrow on connector flange
7 Seal
- Always replace
- To install, place into opening of fuel tank when dry
8 Union nut - 80 Nm
- Use ring nut wrench 3217 to remove and install
9 Harness connector
- For Fuel Pump (FP) and Sender for fuel gauge -G-
- Releasing, See Fig. 1,
10 O-Rings
- Always replace
- Check installation position
11 Return line
- Disconnect to remove fuel tank from connector flange
12 Baffle housing lower part
- With suction jet pump
- Fuel tank not depicted in illustration

Fig. 1 Releasing Harness Connector







- To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a small screwdriver -arrow-.