5 SPD. A/T 01L AWD

Electrical/electronic components and locations





1. Automatic transmission Control Module (TCM) -J217
^ Component location; Refer Fig. 1
^ Removing and installing; Refer to Fig. 2
^ Mufti-pin connector release; Refer to Fig. 3
2. Engine Control Module (ECM)
^ Location; Refer to Fig. 4.
3. ABS Control Module
^ Location; Refer to Fig. 7
4. Data Link Connector (DLC)
^ Location; Refer to Fig. 5.
5. Valve body
^ Location; Refer to Fig. 9
6. Transmission Internal wiring harness with Integrated Transmission Fluid Temperature Sensor (ATF) -G93 Location; Refer to Fig. 6.
7. Multl4unctlon Transmission Range (TR) Switch -F125
^ Location and removing and installing; Refer to Fig. 8
8. Sensor for Transmission RPM -G182
^ Location and removing and installing; Refer to Fig. 10.
9. Sender for Transmission Output RPM -G195
^ Location and removing and installing; Refer to Fig. 11.
10. Speedometer Vehicle Speed Sensor (VSS)-G22
^ Location and removing and installing Fig. 11
11. Selector lever mechanism
12. Tiptronic Switch -F189
^ Location and removing and installing; Refer to Fig. 14
13. Shift Lock solenoid -N110
^ Location and removing and installing; Refer to Fig. 13
14. Throttle Position (TP) Sensor -G69
15. Cruise Control Switch -E45
^ Location; Refer to Fig. 18,
16. Starting Interlock relay -J207
^ Location; Refer to Fig. 15,
17. Transmission range selector lever display _Y6
^ Location: in instrument cluster; Refer to Fig. 16,
18. Kickdown switch -F8
19. Brake Light Switch -F
^ Location; Refer to Fig. 17,

Removing

Fig. 2 TCM -J217, removing and Installing:

^ Remove trim of right -A- column at bottom and right door entry moulding of right front door.
^ Loosen and fold up carpet at right rocker panel at right front door about 20 cm (8 inch).
^ Unclip container at -A- upward.
^ Unclip container at -B- as shown.





^ Unclip control module from container -arrows-
^ Disengage mufti-pin connector and disconnect from control module; Refer to Fig. 3.

Installing: Install in reverse order of removal but note the following:





^ Clip nut -1- must be securely fastened.

Fig. 3 Automatic Transmission Control Module (TCM) -J217, disconnecting multi-pin connector:

^ Switch off ignition and wait for about 30 seconds.
^ To disengage connector, push clip in direction of arrow.
Installation is in reverse order of removal.