Trip Computer: Locations

Fuel tank with attachments, overview of components





1 - Securing strap
^ With spacer, installing location; Refer to Fig. 2
2 - 22 Nm
3 - Fuel supply pipe
^ From fuel filter
^ To fuel rail
^ Press release tab on connection piece to disconnect
4 - Fuel return pipe
^ Mark before disconnecting
^ Press release tab on connection piece to disconnect
^ Clip onto fuel tank
5 - Vent pipe
6 - Ground (GND) connection
^ To eliminate electrostatic charge
^ Position / test procedure; Refer to Fig. 1.
^ Ensure that connector is fitted properly
^ After installation, use an ohmmeter to check the electrical connection of the fuel filler neck on a bare metal part on the body.
^ Specification: approximately 0 ohms
7 - Sealing cap
8 - Seal
^ Replace if damaged 9-22 Nm
10 - Electrical harness connector
^ For fuel tank lock switch
11 - Vent pipe
^ To EVAP canister in rear left wheel housing
^ Clip onto fuel tank
^ Remains on fuel tank when tank is removed
12 - Fuel tank
13 - Bush
14 - Bracket
^ For fuel tank
15 - 22 Nm
16 - Rubber buffer
17 - Washer
18 - 22 Nm
19 - 22 Nm
20 - Securing strap
^ with spacer, installing location; Refer to Fig 2
21 - Retaining clip
^ For heat shield
22 - Heat shield
23 - Retaining clip
^ For heat shield





Fig. 1 Position Ground (GND) connection
- Fit Ground (GND) connection as shown in illustration.
- Ensure that plug connector for Ground (GND) connection is properly seated on metal ring on fuel filler neck (arrow).

CAUTION: After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body:
^ Specification: approximately 0 Ohm





Fig. 2 Installing location of spacers
- Make sure that the spacers for the securing straps are properly fitted directly under seam on fuel tank (arrow).