Bumper Bracket

Front Bumper

Bumper Bracket

- Remove the hex bolt - 3 -.





- Remove clamping washers - 2 - from retaining bolts - arrows -

- Pull bumper - 1 - forward slightly and remove bracket toward front over retaining bolts.

- Tighten bolts - 3 - to 23 Nm when installing.

Removing Tension Strut Brackets





- Bumper cover removed.

- Bumper - 1 - must not be removed.

- Remove bolts - 3 - and remove tension strut brackets -2-.

- Bumper bracket - 4 -.

- To remove towing eye mount - 6 -, remove combination bolt - 7 - from nut - 5 -.

- When installing, tighten bolts to Nm.

- Towing eye mount installed only on the right side.

Removing ACC Sensor





Radar sensor is located behind bumper cover.

- Remove front bumper cover.

- Remove hex bolts - 1 -.

- Remove sensor and disconnect harness connector.

- When installing, tighten hex bolts to 8 Nm.