Front Door: Adjustments

Front Door, Adjusting

Panel gap dimensions







NOTE:
- Rear door must be adjusted.
- Panel gap dimensions can be checked using 3371 adjustment gauge.
- Dimension - A - = 3.5 mm ± 0.5 mm dimension
- - B - = 4.5 mm ± 0.5 mm
- Dimension - C - = 3.5 mm ± 0.5 mm
- Dimension - D - = 0 mm + 1 mm

- The course of the gap must not deviate more than 0.5 mm from parallel.







- Loosen bolts - 1 -.
- Use the markings (arrows - a - and arrows - c - ) for side adjustment.
- Slide striker - 2 - until the door is flush with the contour of the chassis.
- Gasket - 3 - must always be replaced.

NOTE: Door may only be adjusted for depth (towards car interior) and not for height.

- Use the markings (arrows - b - and arrows - d - ) for height adjustment.
- Striker must align in door lock center for correct adjustment.
- Tighten bolts to 25 Nm.