Rear Door Assembly Carrier

Rear Door Assembly Carrier





1 - Rear Door

2 - Window Regulator

• Removing. Refer to => [ Rear Door Window Regulator ] Rear Door Window Regulator.

3 - Assembly Carrier

• The door trim panel is removed.

• Removing:

• Disconnect all electrical wires for the control modules and / or speakers.

• Be sure to install all cable ties, which were cut or loosen, at the same locations where they were prior to removal.

• Remove the window regulator motor. Refer to => [ Rear Door Motor for Window Regulator ] Service and Repair.

• Remove plastic covers on openings - arrows - in assembly carrier => [ Assembly Carrier Cover ].

• Slide down door window approximately 10 cm until drivers - 11 - of door window with bolts - 4 - in openings - arrows - are accessible.

4 - Screw

• Must be screwed out when removing door window or assembly carrier.

• 4 Nm

5 - Bolts

• When removing assembly carrier, remove all bolts.

• 8 Nm

6 - Nut

• 5Nm

7 - Closing Assist Motor

• Removing and installing, refer to => [ Rear Door Closing Aid Motor ] Rear Door Closing Aid Motor.

8 - Window

• Must always be installed together.

9 - Connecting Element

• Preassembly, refer to => [ Preassembly for Connecting Element ].

10 - Cable

• Engage in motor for closing assist, refer to => [ Engaging and Disengaging the Cable ] Rear Door Closing Aid Motor.

11 - Mounts

• Must lie on window regulator drivers, refer to => [ Front Driver ] when installing door windows.

Assembly Carrier Cover





- When removing assembly carrier - 1 - or door window, cover - 2 - must be pulled out.

Front Driver





- When removing door window or assembly carrier - 1 -, remove mount - 2 - of door window driver - 3 -.

- Tighten Torx bolt - 4 - to 4 Nm when installing.

- When installing, make sure window mount - 2 - lies on upper edge of drive - 3 -.

Rear Driver





- When removing door window or assembly carrier - 1 -, unscrew mount - 2 - of door window driver - 3 -.

- Tighten Torx bolt - 4 - to 4 Nm when installing.

- When installing, make sure window mount - 2 - lies on upper edge of drive - 3 -.

Preassembly for Connecting Element





- If necessary, remove aluminum adhesive strips - 2 - which cover borings on assembly carrier - 1 - (only for new parts).

- Insert connecting elements - 3 - into assembly carrier - 1 - and tighten Nuts - 4 - to 20 Nm.