Trim of Display Module For Front Information Display Control Head J685 , Removing and Installing

Trim Of Display Module For Front Information Display Control Head J685, Removing And Installing

Special tools, testers and auxiliary items required







- Trim removal wedge 3409







- Hook 3438

Removing
- Turn selector wheel - 3 - of left air vent above glove compartment fully up.
- Above bottom slat - 2 -, insert two 90 degrees pick tools - 1 - in each of two air vent clips.
- Alternating between left and right side, pull air vent out of opening, taking care to ensure that 90 degrees pick tools remain in position.

NOTE: If necessary, use Hook 3438 to pull air vent out of opening.

- Disconnect connector at air vent.







- Repeat procedure at air vent on right next to instrument panel insert.
- Remove trim panel at bottom left and right edge using Trim removal wedge 3409 - arrow 1-.







- Pull trim panel downward out of display module lugs - arrow 2 -.

Installing
Install in reverse order of removal.