Rear Bumper Access/Start Authorization Antenna

Access/Start Authorization System

Rear Bumper Access/Start Authorization Antenna

Removing





- Remove rear bumper cover.

- Disconnect electrical connector - 2 -.

- Remove screws - arrows -.

- Remove Access/Start Authorization Antenna (in rear bumper) (R136) - item 1 - from bumper cover.

Installing

Install in reverse order of removal, observing the following:

- Install the cover on the rear bumper.

Vehicles with Lane Change Assist

If the bumper cover was removed, the lane change assistance control module (J769)/ (J770) must be calibrated again. Refer to => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing for Calibration.

Tightening Specifications