Interior Mirror, Removing and Installing

Interior Mirror, Removing And Installing

NOTE
- Mirror must be removed if ball joint is not clipped in.
- Ball joint must be clipped in whilst removed, at same time feeding through wiring harness.







1 - Interior mirror
- Automatic anti-glare

Removing
- Remove front roof module.
- Disconnect connector of wire - 4 - from front roof module.
- Remove interior mirror on left side between mounting plate - 7 - and mirror base - 3 -.
- Remove interior mirror.

Installing
- Prior to installation, check that locking pin - 8 - is engaged.
- Guide wire - 4 - through mirror base opening in frame for front roof module.
- Insert right side of mirror base - 3 -.
- Clip in mirror base trim - 2 - on right side.
- On left side, press mirror base trim - 2 - with mirror base - 3 - upward until locking pin - 8 - engages.
- Connect connector - 4 - at roof module.
- Install front roof module.

2 - Mirror base trim
3 - Mirror base
4 - Wire
- Interior mirror-Front roof module
5 - Molded headliner
6 - Frame for front roof module
7 - Base plate
8 - Locking pin