Left Cylinder Head Cover

Left Cylinder Head Cover

Removing

- Remove the engine covers - 1 and 2 - upward.





- Remove the ignition coils.

- Disconnect the crankcase ventilation hose from the cylinder head cover.

- Remove the toothed belt guard.

- Remove the left cylinder head cover bolts in sequence - 12 to 1 -.





- Remove the cylinder head cover.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Replace the cylinder head cover gaskets and ignition coil seals if damaged.

• Replace the bolts for the cylinder head cover if the gasket is damaged.

- Clean sealing surfaces, must be free of oil and grease.

- Apply thin bead of sealant (diameter approximately 5 mm) - arrows - to the edges of the sealing surfaces between the bearing cap and cylinder head.





- Tighten the cylinder head cover bolts in sequence - 1 to 12 -.





Tightening Specifications