Torque Support With Torque Support Valve

Torque Support with Torque Support Valve

Removing

Special tools, testers and auxiliary items required

• Drill

• Stepped quick helix drill bit (24 mm diameter)

• Before raising the vehicle on the hoist (wheels off the ground), activate the vehicle left mode.

- Turn the ignition and remove the ignition key.

- Turn the light switch to "0" position.

- Remove the front noise insulation fasteners - 1 - and noise insulation.





- Remove the front part of the wheel housing liner at the left and right front.

- Remove the front bumper cover.

- Remove the clips - 1 -.





- Remove the bolt - 2 - and remove the cover.

• Note the clips - arrows - when installing.

- Disconnect the intake air duct - 1 - from the Secondary Air Injection (AIR) pump.





- Disconnect the electrical connector - arrow -.





- Disconnect the electrical connector - 1 - from Mass Air Flow (MAF) sensor.





- Loosen the clamp - 2 - and remove the MAF sensor from intake air duct.

- Remove the air filter box screws - arrows -.

- Remove the right headlamp.

- Press the locking mechanisms - arrows - and remove the air guide from the lock carrier at the right front.





- Remove the bolts - arrows -.





- Remove the air guide from the lock carrier at the right rear.

- Mark the holes according to dimensions - a and b - at the lock carrier as shown.





• Dimension - a - = 40 mm.

• Dimension - b - = 55 mm

- Make a 24 mm diameter hole.

• The hole must be pre-bored and then drilled to 24 mm using the stepped quick helix drill bit.

- Unclip the cable clips - arrows -.





- Remove the bolts - 1 and 2 - for the torque support.





- Loosen the bolt - 3 - several turns.

- Remove the torque support bolt - arrow - from the torque support valve (N382).





- Remove the bolts - 2 and 3 -.





- Swivel the torque support aside and disconnect the electrical connector - 1 -.

- Remove the torque support valve.

Installing

Installation is performed in the reverse order of removal, noting the following:

• All cable ties which are opened or cut off when removing the engine, must be replaced in the same position when installing the engine.

• Secure all hose connections using hose clamps appropriate for the model type.

- Connect the electrical connector - 1 - to the torque support valve.





- Install the torque support valve and tighten bolts - 2 and 3 -.

- Turn the knurled nut - 1 - on the torque support valve clockwise until the stop.





- Tighten bolts - 1 and 3 - for the torque support.





- Turn the knurled nut - 1 - by hand counterclockwise until it makes contact at the torque support valve.





- Then, turn the knurled nut one rotation clockwise again.

- Tighten the bolt - arrow - for the torque support valve.





- Clip in the cable clips - arrows -.





- Install the headlamps.

- Install the front bumper cover.

- .

Tightening Specifications

Tightening specifications, refer to => [ Torque Bracket and Support Valve Assembly Overview ] Torque Bracket and Support Valve Assembly Overview.