Drive Plate With Overload Protection

A/C Compressor



Drive Plate with Overload Protection

Removing

- Remove bolts - A -.





• Use a commercially available band wrench with webbed band) to counterhold at drive plate - C -.

Installing

- Position drive plate with overload safeguard - B - onto drive plate - C -.

- Insert bolts - A - and tighten them by hand.

- Check run-out of drive plate - B -. Refer to => [ Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] .

- Tighten bolts - A - (tightening torque 10 Nm).

- Check run-out of drive plate - B - again. Refer to=> [ Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] .