Procedures

Brake light switch, removing and installing

Note: Remove brake light switch to adjust.
To ensure a secure fit, the switch may be installed only once.

Removing
- Remove storage compartment on driver's side.

- Unplug electrical connector.
- Remove brake light switch by turning counterclockwise through 45 °.

Installing
Install in reverse sequence; note the following points:





- Pull brake light switch plunger fully out -arrow-.
- Install retainer tabs -1- and -2- on switch into recesses of installation hole.
- Install storage compartment on driver's side.

Note:
^ When installing brake light switch, do not operate brake pedal.
^ The plunger adjusts itself automatically when the brake light switch is inserted.





- Guide switch through installation hole, press against pedal and secure by turning 45 ° to right.

After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).