Sprocket For Oil Pump on Crankshaft, Removing and Installing

Chain sprocket for oil pump on crankshaft, removing and installing
Removing
Removing and installing front sealing flange and oil pump drive chain, Refer to Timing Cover, Service and Repair.





- Pull chain sprocket off crankshaft using a normal commercial-type puller -2- : use a suitable washer -1- to protect end of crankshaft.

Installing
- Heat chain sprocket in oven for about 15 minutes at 220°C.

Note:
^ Wear protective.
^ Installation position: it must be possible to read the lettering on the chain sprocket.





- Using pliers, fit chain sprocket on end of crankshaft and push against stop on crankshaft with drift sleeve 30-100. If necessary knock on carefully using a plastic hammer.
Removing and installing front sealing flange and oil pump drive chain, Refer to Timing Cover, Service and Repair.