01V 5 Speed Automatic

Electrical/electronic components and locations





1. Automatic transmission control module -J217-
^ Location; Refer to Fig. 1
^ Removing; Refer to Fig. 2.
^ Installing; Refer to Fig. 3.
2. Engine control module
^ Location; Refer to Fig. 4
3. Data Link Connector (DLC)
^ Location; Refer to Fig. 5.
4. Conductor strip with transmission oil temperature sender (ATF) -G93-
^ Location; Refer to Fig. 7
5. Valve body
^ Location; Refer to Fig. 6
6. Multi-function switch -F1 25-
^ Fitting location and removing and installing; Refer to Fig.
7. Transmission Input speed sender -G182-
^ Fitting location and removing and installing; Refer to Fig. 12
8. Transmission speed sender -G38- (also referred to as transmission output RPM -G195-)
^ Fitting location and removing and installing; Refer to Fig. 11
9. Tiptronic switch -F1 89-
^ Fitting location and removing and installing; Refer to Fig. 9.
10. Selector lever lock solenoid -N110-
^ Location; Refer to Fig. 14
11. Throttle valve potentiometer -GS9-
^ Location; Refer to Fig. 15,
12. Cruise control switch -E45-
13. Starter Inhibitor relay -J207-
^ Location; Refer to Fig. 16,
14. Selector lever position display -YS-
^ Location; Refer to Fig. 17
15. Kick down switch -F8-
^ Location; Refer to Fig. 18
16. Brake light switch -F-
^ Location; Refer to Fig. 19

Fig. 21 Removing automatic transmission control module -J217-:

Removing
^ Removing lower right A-pillar trim and right door sill trim piece.
^ Detach carpeting from inside of sill (right-side) below front door, and raise carpeting approximately 20 cm.
^ Unclip box at -A- by pulling it upward.





^ Unclip box at -B- as shown.
^ Unclip TCM from box (arrows).
^ Release catch on multi-pin connector and disconnect connector from TCM; Refer to Fig. 22

Installing:
Installation is the reverse of removal, with the following additional steps:





^ Check that clip -1- is properly secured:

Fig. 22 Installing automatic transmission control module -J217-:

^ Switch ignition off and wait approximately 30 seconds.
^ Release connector by pressing catch in direction of arrow.
Installation is the reverse of removal.