01L 5 Speed Automatic AWD

5 SPD. A/T 01L AWD

Drive gear for speedometer Vehicle Speed Sensor (VSS) -G22-, replacing





Special tools and equipment
^ VW401 Thrust plate
^ VW402 Thrust plate
^ VW415A Tube
^ VW412 Thrust disc
^ 32-109 Driving sleeve

Removing
^ Remove left drive flange.





^ Remove circlip (arrow A) for ball bearing.





^ Press out drive flange from mounting bracket for left drive flange using VW412 thrust disc.
Set mounting bracket onto VW401 and VW402 thrust plates while doing so.

Note: Hold drive flange with one hand to keep from falling out toward bottom.

^ Pull off drive gear for speedometer Vehicle Speed Sensor (VSS) -G22- from drive flange and remove from mounting bracket.

Installing





^ Set magnetic ring for speedometer Vehicle Speed Sensor (VSS) -G22- (arrow) onto drive flange.

Note: The followers at magnetic ring must engage in grooves of drive flange. If necessary, coat contact surface with Vaseline to affix magnetic ring in installation position.





^ Press mounting bracket with ball bearing onto left drive flange.
When pressing, set drive flange onto VW401 thrust plate. Press on mounting bracket with VW412 thrust plate, VW415 tube and 32-109 driving sleeve.





^ Insert circlip (arrow -A-).
^ Install left drive flange.
^ Check and top off transmission fluid in rear final drive of automatic transmission.





Tightening torques
Heat shield to transmission 23 Nm
Mounting bracket for left drive flange at transmission 23 Nm