Coolant Fan 2 -V177- (Right), Removing and Installing

Coolant fan 2 -V177- (right), removing and installing

Removing

Note: All cable ties unfastened or cut open on removal are to be re-attached in same position on installation.





- Remove cover (arrow) at power steering reservoir.
- Move lock carrier to service position; Refer to Body and Frame; Radiator Support, Service and Repair [1][2]Procedures





- Take connector -2- out of holder and disconnect.
- Move wiring harness clear of radiator fan.





- Remove strut -1 -.
- Remove bolts (arrows) and remove fan.

Installing

Install in reverse order, paying attention to the following:

Note: Re-attach all cable ties at same location on installation.

- Install lock carrier with attachments.
; Refer to Body and Frame; Radiator Support, Service and Repair [1][2]Procedures





- Allow stop for torque reaction support to settle on rubber buffer for torque reaction support and tighten bolts (arrows) to 28 Nm.

- Install front bumper.
- Adjust headlights.





Tightening torques